Boat Cover Support Guide

Boat Cover Support Installation Instructions

(This system will fit any boat between 6 and 9 feet in width)

1. Before starting the boat installation process, ensure there are no loose items or equipment inside the boat that could interfere with the installation.

2. Identify the best locations for the anchors. If you are using one set, place it in the middle of the boat; if you have two sets, position them an equal distance apart.

3. Utilize a 1/8 inch drill to create anchor holes, drilling 1 inch deep for each.

4. Secure the provided screws using a Phillips screwdriver to ensure a strong hold.

5. Once your anchors are secure, slide the ends of the support slats into the anchors while adjusting the connector approximately 12 inches above the top of the boat rail. Keep in mind that every boat is unique and may require slight adjustments for the perfect cover height.

6. Start placing the canvas cover in the boat from the water side. Adjust the connector to the appropriate height to facilitate the easy installation of snapping the canvas in place along the entire length of the boat.

7. Rotate the horizontal helper arms outward to provide proper support beneath the canvas, ensuring a stable installation.